AUXILIARY CONTROL DEVICE
Article Text (p. 2)
1983 Mazda RX7
For www.iluvmyrx7.com
Copyright © 1998 Mitchell Repair Information Company, LLC
Sunday, August 26, 2001 04:58PM
CHOKE RELAY
1) Disconnect coupler from relay. With engine off and no
power applied, check continuity of terminals.
2) There should be continuity between No. 1 and No. 2. There
should be no continuity between No. 3 and No. 4.
3) Connect a wire from battery positive post to terminal No.
6 and battery negative post to terminal No. 5. There should be
continuity between No. 3 and No. 4. There should be no continuity
between No. 1 and No. 2.
Fig. 2: Choke Relay Terminal Locations
CHOKE SWITCH
1) Unplug connector from choke switch. Check continuity
between numbered terminals in connector using an ohmmeter.
2) Continuity should exist between terminals No. 3 and No. 7
when choke knob is pulled to about 0.4" (10 mm.). Continuity should
exist between terminals No. 6 and No. 8 when choke knob is at any
position. See Fig. 3 for terminal locations.
Fig. 3: Choke Switch Terminal Locations
WATER TEMPERATURE SWITCHES
To Next Page
