Mazda 1983 RX7 - Hot Start Assist; Adjusting Hot Start Relay Cable

CHOKE - ELECTRIC ASSIST
Article Text (p. 4)
1983 Mazda RX7
For www.iluvmyrx7.com
Copyright © 1998 Mitchell Repair Information Company, LLC
Sunday, August 26, 2001 04:58PM
HOT START ASSIST
CABLE ADJUSTMENT
1) Remove hot start assist cable lock spring from cable
bracket. Slowly pull outer cable until hot start lever just touches
stopper lever. Check clearance between cable bracket and cable lock
nut.
2) If clearance is not .02-.08" (0.5-2.0 mm), adjust
clearance by turning lock nut. Recheck clearance and install lock
spring.
Fig. 5: Adjusting Hot Start Relay Cable
END OF ARTICLE