FILLING COOLING SYSTEM CAT. 3, NO. 008/87
Article Text (p. 2)
1983 Mazda RX7
For www.iluvmyrx7.com
Copyright © 1998 Mitchell Repair Information Company, LLC
Saturday, September 08, 2001 09:18AM
fully open). Check that there are no coolant leaks.
Add additional coolant as needed so that the radiator is full and the
coolant level is at the "FULL" mark on the coolant reservoir.
NOTE: If you encounter a reservoir bottle that is empty, it is likely
that the level of coolant inside the radiator is also low. In
such a case always....
1. Wait until the engine is cool and then remove the radiator cap. Add
coolant as needed to bring the level inside the radiator up to
full.
2. Pressure check the radiator and radiator. Also perform general
check of coolant system.
END OF ARTICLE
To Next Page
Loading...
