ON-BOARD DIAGNOSTIC
01–02–23
01–02
PID/DATA MONITOR AND RECORD [LF]
E5U010200000N05
• The PID/DATA monitor items are shown below.
PID/DATA monitor table (reference)
Item Definition Unit/Condition
PCM
terminal
AAT Ambient air temperature °C—
AC_REQ Refrigerant pressure switch (high, low) On/Off 1AU
ACCS A/C relay On/Off 1I
AFR Air/fuel ratio — 2AD
AFR_ACT Actual air/fuel ratio — —
ALTF Generator field coil control duty value % 2AI
ALTT V Generator output voltage V 2AJ
APP Accelerator pedal position % 1AO, 1AP
APP1 APP sensor No.1
%
1AO
V
APP2 APP sensor No.2
%
1AP
V
ARPMDES Target engine speed RPM —
BARO Barometric pressure
Pa
—
V
BOO Brake switch On/Off 1AB, 1AF
CATT11_DSD Catalyst temperature °C—
CHRGLP Generator warning light On/Off —
COLP Refrigerant pressure switch (middle) On/Off 1J
CPP
*1
Clutch pedal position On/Off 1D
CPP/PNP
*1
Shift lever position Drive/Neutral 1X
DTCCNT Number of DTC detected — —
ECT Engine coolant temperature
°C
2AH
V
EQ_RAT11 Actual lambda signal — —
EQ_RAT11_DSD Target lambda — —
ETC_ACT Throttle control ° —
ETC_DSD Throttle control desired
%
—
°
EVAPCP Purge solenoid valve duty value % 2C
FAN1 Cooling fan relay No.1 control signal On/Off 1M
FAN2 Cooling fan relay No.2 control signal On/Off 1N
FAN3 Cooling fan relay No.3 control signal On/Off 1R
FLI Fuel level % —
FP Fuel pump relay On/Off 1H
FUELPW Fuel injector duration ms
2BB, 2BC,
2BD, 2AZ
FUELSYS Fuel system status
OL/CL/
OL–Drive/
OL–Fault/
CL–Fault
—
GENVDSD Target generator voltage V —
HTR11 Front HO2S heater control On/Off 2BG
HTR12 Rear HO2S heater control On/Off 2BE
IAT Intake air temperature
°C
1AT
V
IMTV Variable intake air control On/Off 2J
INGEAR Gears are engaged On/Off
1D
*1
,1X
*1
,
—
*6
IVS CTP condition Idle/Off Idle —
KNOCKER Knocking retard ° 2U
To Next Page
Loading...
