McConnel ROBOCUT2 RC40 - Page 80

71
McCONNEL
Error
Cause
Solution
210
Engine alarm
Oil level indicator: the energy consumption measured by the
ECU does not fall within the permissible range or the maximum
permissible temperature of the ECU component that powers
the lamp has been exceeded
211
Motor CAN message reception error;
Check the engine, check the CAN line, check the LE70. If the
error persists, check the engine control unit.
500
Problems with output pin A24 of control unit LE70
Check the cable; Controller output error;
501
Problems with output pin A13 of control unit LE70
Check the cable; Controller output error;
502
Problems with output pin A01 of control unit LE70
Check the cable; Controller output error;
503
Problems with output pin A02 of control unit LE70
Check the cable; Controller output error;
504
Problems with output pin A03 of control unit LE70
Check the cable; Controller output error;
505
Problems with output pin A04 of control unit LE70
Check the cable; Controller output error;
506
Problems with output pin A05 of control unit LE70
Check the cable; Controller output error;
507
Problems with output pin A06 of control unit LE70
Check the cable; Controller output error;
508
Problems with output pin A07 of control unit LE70
Check the cable; Controller output error;
509
Problems with output pin A08 of control unit LE70
Check the cable; Controller output error;
510
Problems with output pin A09 of control unit LE70
Check the cable; Controller output error;
511
Problems with output pin A10 of control unit LE70
Check the cable; Controller output error;
512
Problems with output pin A11 of control unit LE70
Check the cable; Controller output error;
513
Problems with output pin A12 of control unit LE70
Check the cable; Controller output error;
514
Problems with output pin A23 of control unit LE70
Check the cable; Controller output error;
515
Problems with output pin A35 of control unit LE70
Check the cable; Controller output error;
516
Problems with output pin B24 of control unit LE70
Check the cable; Controller output error;
517
Problems with output pin B13 of control unit LE70
Check the cable; Controller output error;
518
Problems with output pin B01 of control unit LE70
Check the cable; Controller output error;
519
Problems with output pin B02 of control unit LE70
Check the cable; Controller output error;
520
Problems with output pin B03 of control unit LE70
Check the cable; Controller output error;
521
Problems with output pin B04 of control unit LE70
Check the cable; Controller output error;
522
Problems with output pin B05 of control unit LE70
Check the cable; Controller output error;
523
Problems with output pin B06 of control unit LE70
Check the cable; Controller output error;
524
Problems with output pin B07 of control unit LE70
Check the cable; Controller output error;
525
Problems with output pin B08 of control unit LE70
Check the cable; Controller output error;
526
Problems with output pin B09 of control unit LE70
Check the cable; Controller output error;
527
Problems with output pin B10 of control unit LE70
Check the cable; Controller output error;
528
Problems with output pin B11 of control unit LE70
Check the cable; Controller output error;
529
Problems with output pin B12 of control unit LE70
Check the cable; Controller output error;
530
Problems with output pin B23 of control unit LE70
Check the cable; Controller output error;
531
Problems with output pin B35 of control unit LE70
Check the cable; Controller output error;
If the fault or the reason for it is not indicated in the list of faults shown, contact McConnel in order for repairs to be carried out.