5. If there is a continuity reading detected for C and P
connections the secondary fields will display with a tick and
background will be green.
6. To start the test press the TEST button.
7. The test runs for a few seconds, then automatically stops.
8. During the tests,
The primary field displays the result with the actual
current being delivered. As the resistance gets higher the
current will get lower.
The secondary field displays the continuity on the Current
(C1-C2) and potential (P1-P2) circuits.
9. The result can be saved by pressing the SAVE button. A
message will inform you the data was saved and which asset
ID it was saved to.
10. To restart the test, press the TEST button again.
DLRO Digital Low Resistance Ohmmeter
www.megger.com 39
To Next Page
Loading...
