2-3
INTRODUCTION MA-5082-ENG B4 VS ADHESIVE MELTER MANUAL
Control of external pumping and internal speed_Switches in the
position ok ‘ext’ and ref ’int’. This mode of operation is performed
through external pumping control and manual speed control.
Control of external pumping and speed_Switches in the position
ok ‘ext’ and ref ’ext’. In this working mode, both pumping and
speed are controlled from the main machine. Speed is controlled
by means of an external 0-10 V signal sent from the main
machine.
Standby mode_The hot-melt melter remains in a resting state, with
the materials kept at (programmable) temperature values below the
pre-selected value. The pump remains deactivated.
Alarm mode_The hot-melt melter detects a malfunction and warns
the operator of this event. The pump remains deactivated.
Stop mode_The hot-melt melter remains off, without heating the
materials and with the pump deactivated. The electrical and pneumatic
supply remains activated between the network and the system,
however.
Melter identification
You will need your melter model and reference when ordering spare parts or
requesting support from our Technical Service Centre.
This data and other technical information can be found on the nameplate
located on the side of the melter base.
Focke Meler Gluing Solutions, S.A.
Pol. Arazuri-Orkoien, c/B, nº3 A
E-31170 Arazuri-Navarra-Spain
www.meler.eu
Part NO./
Ref.
Serial NO./
NºSerie
Model/
Modelo
Power
supply/
Alim.
To Next Page
Loading...
