FOCKE MELER GLUING SOLUTIONS
2-2
INTRODUCTION
Description
The ‘MICRON+’ are designed for use with ‘meler’ hoses and applicators in hot-
melt adhesive applications. Their different variations – line, coating or swirl-
spray – cover a wide range of applications, being very versatile in all markets
where they are used.
Modes of operation
The ‘MICRON+’ series hot-melt melters/applicators may be used in all of the
following modes:
Work mode_The hot-melt melter/applicator keeps materials hot at the
pre-selected temperature indicated on the display. The pump is kept
activated, waiting for the consumption command when one or more
application applicators are activated.
Standby mode_The hot-melt melter/applicator remains in a resting
state, with the materials kept at (programmable) temperature values
below the pre-selected value. The pump remains deactivated.
Alarm mode_The hot-melt melter/applicator detects a malfunction
and warns the operator of this event. The pump remains deactivated.
OFF mode_The hot-melt melter/applicator remains off, without
heating the materials and with the pump deactivated. The electrical
and pneumatic supply remains activated between the network and the
system, however.
Hot-melt melter/applicator identification
When placing orders for replacement parts or requesting help from our
service center, you should know the model and reference number of your hot-
melt melter/applicator.
To Next Page
Loading...
