Meler Micron + 10 - MICRON + Range Option Accessories; 3 X400 W;O Neutral Power Supply Voltage Option; Automatic Feeder Option; Warning Light Option

MA-5162-ENG MICRON
+
PISTON ADHESIVE MELTERINTRODUCTION
2-7
MICRON
+
range option accessories
If some of the different machine configuration options have been chosen, it
will be necessary the following accessories:
3x400 w/o neutral power supply voltage option
The transformer for the 5, 10 and 20l machine will be included.
The MICRON+ 35 does not allow ‘400’ version connected to 3x400+T w/o
neutral
Automatic feeder option
The automatic adhesive feeder will be included and is the same for the 5, 10,
20 and 35l machines. Suction lance and hose have to be order separately.
Warning light option
The warning light must be requested separately. There is a choice of the low
level and colourless (white) indicator light or the low level and temperature OK
indicator light (green). They are both the same for all machines.
VP option
The VP proportional valve system must be requested separately. It is the same
for all machines in all cases.
Optional equipment
To increase the functionality of the melter machines, the following optional
elements can be incorporated:
• Low level of melted adhesive detection system. This can be fitted to
all the machines in float switch or capacitive sensor options.
• Adaptation plate for previous models. For adapting ST machines, the
previous 4, 8 and 16l machines and MICRON range 5, 10 20 and 35
liters.
• 4 casters: Only for 20 and 35l machines.