MA-5162-ENG MICRON
+
PISTON ADHESIVE MELTERMELTER OPERATION
4-1
4. MELTER OPERATION
In this section we will introduce the method for using the melter. Although its
operation is very simple, it should not be used by untrained personnel.
Warning: Improper use may cause damage to the machine or injury and even
death to the person using it.
General information
There are three large groups of components with thermal control in a hot-
melt installation: the fusion unit, the transport hoses and the applicators. All
of these are controlled from the front panel of the melter equipment.
The first large group is the tank (T) an distributor (D) group and they have
separate programmable controls.
The second group is the hose group. They are identified on the front panel,
depending on the equipment model, by number, from number 1.1 to number
6.1 . Each one has its own set point value.
The third group is the applicators group. It is identified on the front panel,
depending on the equipment model, by number from number 1.2 to number
6.2 . Each one has its own set point value.
The hose and applicator numbers are automatically assigned to the hose/
applicator channel they are connected to on the rear part of the melter.
154
154
A
15:35
°C
08:31
185 170
1
154 154
2
100 100
3
--- ---
4
5
42 42
6
B
1
2
3
4
5
6
To Next Page
Loading...
