Mercury 40 Service Manual

BIGFOOT GEAR HOUSING
Page 6B-18 90-828631R3 MARCH 1999
8. If bearing is rusted or does not roll freely, replace bearing. Remove bearing and oil seals
using Mandrel* (91-36569) and Driver Rod* (91-37323). Discard oil seals.
NOTE: * From Bearing Removal and Installation Kit (91-31229A7)
51264
a
b
c
91-37323
91-36569
a-Bearing
b-Mandrel (91-26569)
c-Driver Rod (91-37323)
9. Remove (if not removed with bearing in Step 9) propeller shaft seals and bearing carrier
O-ring.
51263
a
a-O-ring

Mercury 40 Specifications

General

Horsepower	40 hp
Starting System	Electric
Steering	Remote
Fuel Induction System	EFI (Electronic Fuel Injection)
Shaft Length	20"
Full Throttle RPM Range	6000