73
Chapter 4 Congure the Router in Wireless Router Mode
2. Give a Username to this account.
3. View the Address of the virtual interface assigned to this account. Do NOT change
it unless necessary.
4. Trac sent from the WireGard VPN client to the allowed IPs (client) will be transmitted
through the tunnel. By default, all network trac from clients will be transmitted
through the tunnel. Do NOT change it unless necessary.
5. Trac sent from the WireGard VPN server to the allowed IPs (server) will be
transmitted through the tunnel. Do NOT change it unless necessary.
6. Enable or disable Pre-shared Key.
7. Click SAVE.
Note: One account can only be used by one WireGuard VPN client at the same time to connect to the WireGuard VPN server.
To Next Page
Loading...
