Metronix ARS 2100 SE Series User Manual

Page 153
Error message Meaning of the error message Measures
Main
index
Sub
index
5 EtherCAT: faulty cyclic data
transfer
Check the EtherCAT wiring.
Check the configuration of the master.
63 0 EtherCAT: defective module Technology module defective?
Replace the technology module.
1 EtherCAT: invalid data Check the protocol.
Check the EtherCAT wiring.
2 EtherCAT:
TPDO data has not been read
Reduce the cycle time (EtherCAT bus).
3 EtherCAT:
no distributed clocks active
Check whether the master supports the
“distributed clocks” feature.
If necessary, contact the Technical Support.
4 Missing SYNC message in IPO
cycle
Check the cycle times of the servo drive and of
the control system.
64 0 DeviceNet: duplicated MAC ID Change the MAC ID.
1 DeviceNet: bus power lost Check the DeviceNet wiring.
2 DeviceNet: overflow of receive
buffer
Reduce the number of messages per time unit
during the transmission.
3 DeviceNet: overflow of transmit
buffer
Reduce the number of message per time unit
that are to be transmitted.
4 DeviceNet: IO send error Please contact the Technical Support.
5 DeviceNet: bus Off Check the DeviceNet wiring.
6 DeviceNet:
CAN controller overflow
Please contact the Technical Support.
65 0 DeviceNet: no module Technology module defective?
Replace the technology module.
1 DeviceNet: I/O connection
timeout
Please contact the Technical Support.
Product Manual „Servo drives ARS 2100 SE“ Version 5.0

Metronix ARS 2100 SE Series Specifications

General

Brand	Metronix
Model	ARS 2100 SE Series
Category	Servo Drives
Language	English