Miele CVA610 - Base Plate - Removal

Technical Information
45
C
VA
6
1
0
C
offee
Sy
stem
5.6 Base Plate - Removal
1. Remove the Lid, Mains and Rear Panel (5.1 to 5.3)
2. Open the door.
3. Remove the grounds container.
4. Remove the water tank.
5. Check if water is present in the drip tray with a finger through
the opening under the water container.
6. If water is present, remove it via a suitable device / tool.
7. Remove the percolator unit.
8. Remove the coffee beans from their container.
9. Remove the base plate fixing screws.
10. Tilt the unit onto its rear.
11. Remove the base plate and disconnect its earth lead.
Figure 5-6: Base Plate – Removal