Miele CVA610 - Water Path Leakage Test

Technical Information
85
C
VA
6
1
0
C
offee
Sy
stem
5.47 Water Path Leakage Test
Should water be present in bottom of the appliance (i.e.
Watersystem Fault); or a leak is suspected the following procedure
can be used to locate the source of the leak.
Caution
The Heaters are hot during this test, and hot water under
pressure could leak from the system.
1. Fill the Water Tank
2. Place the appliance into the Service Mode
3. Quickly turn the selector knob to the “Programming” position
4. Press and hold all three coffee buttons - check for signs of leakage
(dripping, squirting etc...) hold buttons as long as necessary.
5. Release the three coffee buttons to end the test