Technical Information
55
VA
1
offee
stem
5.17 Coffee Dispensing Nozzle - Fitting
Refer to figure 5-16.
1. Slide the outlet (Item 7), onto the connection hose (Item 6).
2. Position the moveable coffee dispensing nozzle, (Item 9), in the
cover (Item 10).
3. Clip the outlet (Item 7), in the cover (Item 10).
Note
The two fixing screws for the coffee dispensing nozzle should be
tightened by hand only as they can easily be over tightened.
4. Fit the Coffee Dispensing Nozzle in the frame. Using a suitable
bit, tighten the two fixing screws by hand.
5. Refit the white panel and screw it in position.
To Next Page
Loading...
