Miele S 528 - Fault Repair: Suction, Power, and Elbow Problems

Technical Information
64
S 500 & S 600 Canister Vacuums
3 Fault Repair
3.1 Suction Power Is Too Low
Cause:
Bag jammed between the casing top and the cover frame.
Remedy:
Replace the bag. See Section 010-4.6.
Note:
Do not open out the bag. Install it as it is when removed from its packaging.
Cause:
Floor attachment or suction hose blocked.
Remedy:
Clean the floor attachment or suction hose.
Cause:
Filter clogged.
Remedy:
Replace all filters. See Sections 010-4.7 through 010-4.10.
Cause:
Seal or sealing ring not seated correctly.
Remedy:
Check for correct seating.
3.2 Elbow Not Seated Correctly in the Suction Opening
Cause:
The hygienic slide shutter slides in front of the suction opening.
Remedy:
Replace the slide shutter. See Section 020-4.9.
3.3 Elbow Blocked
Cause:
The hygienic slide shutter slides in front of the suction opening.
Remedy:
Replace the slide shutter. See Section 020-4.9.
3.4 Appliance Always Operates at Full Power
Cause:
Electronic in handle is defective.
Remedy:
Replace the suction hose with electronic; see Section 055-4.1.
Cause:
Poor contact between slip ring and electronic.
Remedy:
Replace the suction hose with electronic; see Section 055-4.1.