Milestone Srl MA213-003 – DMA-80 EVO – User Manual
136
Switch on the machine and wait about 20 minutes
before to connect the amalgamator.
During this time you should see the condensate
(bubble of water) gets out from the catalyst tube.
The catalyst is draining.
After 20 minutes, connect the amalgamator in the
right position.
The amalgamator tube has a little groove on the
glass to indicate the direction of the flow.
The amalgamator must be installed with the
groove close to the cuvette in order to avoid that
the material inside moves out during the flow
passage.
FLOW
FLOW
To Next Page
