Milestone DMA-80 evo - 1 SAFETY RULES; 1.1 General Information; 1.2 Safety rules for start-up; 1.3 Safety rules in operations

Milestone Srl MA213-003 – DMA-80 EVO – User Manual
6
1 SAFETY RULES
1.1 General Information
 Please read carefully this operator manual before switching on the system and follow its
prescriptions with the utmost care.
 In case the system has been delivered with additional accessories, also carefully read the
instruction manuals of such accessories.
 Follow with particular attention the recommended instructions for Service and Maintenance.
 This Operator Manual is part of the delivery, hence must be always kept together with the
instrument on its working place.
 It is imperative that every person operating this system has read and fully understood this
manual.
 The non-observance of the instructions contained herein or improper use may involve
damages/injuries that are not covered by product liability!
 The national ruling and international safety norms in working environment shall in any case be
observed under user’s responsibility.
 It is also user’s responsibility to keep constantly updated all safety norms ruling in the country
or operation.
 All additional safety guidelines of this manual and the safety guidelines on the unit are as well
to be noted.
Information = indicates important information/recommendations for the user.
Attention = means that the non-observance of the warning may cause damages to unit or
properties.
Warning means that the non-observance of the warning may cause injuries, even severe, to
people.
1.2 Safety rules for start-up
 First start-up of the system must exclusively be carried out by authorized and trained service
engineers appointed by Milestone.
1.3 Safety rules in operations
 The DMA-80 EVO device is intended exclusively to measure the mercury content in the
samples. Any different use or any other use is to be considered as improper. The manufacturer
liability will not cover any resulting damages. The risk is exclusively borne by the operator/user.
 The unit must only be operated within the power limits set forth by the technical specifications.
 The unit must be operated exclusively by specially trained people.
 All electrical parts must always be protected from wet and humidity.
 The unit must be kept clean.
 Note all the safety instructions indicated in this manual, that can be treated as accident
prevention regulations, and the general accepted rules to work with devices.