Milestone Srl MA213-003 – DMA-80 EVO – User Manual
31
Provide a suitable space to
position the device and place it
on the floor. The unit requires
approx. 15 cm on each side to
allow adequate airflow.
Check that you have appropriate power supply
and that the main voltage corresponds with the
one shown on the plate fixed to the compressor.
Make sure that the outlet is closed by turning
the pressure regulator fully anti-clockwise,
then connect one end of the proper air tubing Ø
6/4 without male connector, present in the
accessories box of the DMA-80 unit.
Connect the other end with male connector to
the inlet of the DMA-80 unit.
To Next Page
Loading...
