Chapter5 Troubleshooting
5-12
ERROR 171
NEW HEAD CONNECT
An error occurred in the power supply
system of the main PCB.
• Turn off the power on the machine and turn it
on after a while.
If displaying again, contact your local distrib-
utor, our sales office, or service center.
ERROR 18a
Main PCB V_CORE
An error occurred in the power supply of
the main PCB.
ERROR 18c
Main PCB V12
ERROR 18e
FLS NOT COMP
Detected an error in the waveform for
the printing.
ERROR 18f
OFFSET START
ERROR 18f
OFFSET END
ERROR 1d9
Main PCB V48-1
An error occurred in the power supply of
the main PCB.
ERROR b1b
BaseIO PCB Vpow-s
An error occurred in the power supply of
the BaseIO PCB.
ERROR b1c
BaseIO PCB V24
ERROR b1d
BaseIO PCB V24-A
ERROR b21
SLIDER1 PCB V3R3
An error occurred in the power supply of
the slider M PCB.
ERROR b22
SLIDER1 PCB V2R5
ERROR b23
SLIDER1 PCB V1R8
ERROR b24
SLIDER1 PCB V1R2
ERROR b21
SLIDER2 PCB V3R3
ERROR b22
SLIDER2 PCB V2R5
ERROR b23
SLIDER2 PCB V1R8
ERROR b24
SLIDER2 PCB V1R2
ERROR 1e6
PRAM Size Shortage
Memory size is insufficient.
ERROR 201
COMMAND ERROR
Data other than print data was received.
Or, an error occurred in the transmitted
print data.
• Securely connect the interface cable.
Use an interface cable conforming to the
standard.
ERROR 202
PARAMETER ERROR
An error occurred in the transmitted print
data.
ERROR 206
PRINTING MODE
The machine received print data with
unprintable conditions.
• Check the print data output condition of the
RIP software.
• Check the profile.
• If displaying again, contact your local distrib-
utor, our sales office, or service center.
ERROR 304
USB INIT ERR
An error occurred in the USB communi-
cation.
• Turn off the power on the machine and turn it
on after a while.
If displaying again, contact your local distrib-
utor, our sales office, or service center.
ERROR 305
USB TIME OUT
ERROR 307
MCFD File IF Error
An error occurred while accessing the
printing condition data.
ERROR 401
MOTOR X
An excessive load was applied to the X
motor.
Display Cause Measures
To Next Page
Loading...
