MIMAKI UJV-160 - Head Wiping

4-26
Head Wiping
When turning the power of this machine on, the head is automatically wiped to avoid the dirt of media.
1
When <LOCAL> is displayed, press the
key.
2
Select the [MAINTENANCE] with the
key, and press the
key.
3
Select the [WIPE HEAD] with the
key, and press the key.
4
Select wiping or not for each head, and
press the key.
(1) Select the head with the key.
(2) Select wiping or not (“*” marked) with the key.
• When not wiping the all heads, select “*” for the all heads.
5
Select the number of wiping, and press
the key.
• Press the key to select the number of wiping (1 to 9).
6
Press the key.
• Wiping starts.
7
When the wiping ends, press the key to finish.
• The wiping starts when the head reaches the set temperature after turning the power on.
• Wiping here is for avoiding stain of the media, therefore the used ink is a very little.
• Until the wiping is finished, do not operate this machine.
<LOCAL . 1>
FUNCTION
FUNCT I ON
MA I NTENANCE < ENT >
ENTER
MA I NTENANCE
WI PE HEAD <e n t >
ENTER
WI PE HEAD
HEAD : MMCCYYKK
ENTER
WI PE HEAD
WI PE NUM . : 1
ENTER
WI PE HEAD
WI PE START : en t
ENTER
END