MIMAKI UJV-160 - CHAPTER 2 Basic Operations

In this chapter, the procedure from media preparation to drawing
are explained.
Operation flow ...................................... 2-2
Turning the power ON/OFF.................. 2-4
Turning the power ON ..............................2-4
Turning the power OFF ............................2-5
Maintenance operation at startup .............2-6
Preventing nozzle missing while
power-off ..................................................2-8
Setting media...................................... 2-12
Setting roll media ....................................2-12
Setting leaf media ...................................2-18
Setting rigid media ..................................2-20
Adjusting the head height .......................2-26
Detect the media width ........................... 2-28
Changing the print origin ........................2-30
Preparing Heaters............................... 2-32
Changing temperature settings of the
heater .....................................................2-32
Confirming the heater temperature .........2-33
Test drawing ....................................... 2-34
Head cleaning ..................................... 2-36
Cleaning by Normal or Hard ...................2-36
Cleaning by Wiping .................................2-37
Drawing an image from data ............. 2-38
Starting the drawing ................................2-38
Cancelling the drawing ...........................2-39
Subtank Maintenance .............................2-40
CHAPTER 2
Basic Operations