2-12
Setting media
This machine can be used with roll media and leaf media.
For the media to be used, refer to P.1-13 "Usable media size".
Setting roll media
Set roll media to the roll holder on the back of this machine.
1
Fix the left roll holder on the back of the
machine.
( 1 ) Loosen the roll holder fixing screw.
( 2 ) Move the roll holder to the media setting position.
( 3 ) Tighten the roll holder fixing screw.
2
Set the roll media core to the left roll
holder.
• Push to the roll holder until the core stops.
3
Set the roll media core to the right roll
holder.
( 1 ) Loosen the roll holder fixing screw.
( 2 ) Move the roll holder to the media setting position.
( 3 ) Insert the roll holder into the core.
( 4 ) Tighten the roll holder fixing screw.
4
Raise the clamp lever on the back of
this machine.
• To prevent the rigid media being jammed into the Y bar, raise the head in advance.
( P.2-26)
To Next Page
Loading...
