Check first when a trouble occurred
5-3
5
In Case of Trouble
Problems of drawing result
If the drawing result has a problem, follow the table below. If the problem does not improve after that, con-
tact a distributor in your district or our office.
Nozzle clogging
If nozzle clogging is not solved after the head cleaning of P.2-36, check the following 2 items.
Execute subtank maintenance with the operation of P.4-25.
Replace ink with the operation of P.4-5.
Problem Solution
Lines / blur (1) Execute the head cleaning. ( P.2-36)
(2)If there is slips of paper in the head path, remove them.
Large ink droplet on media (1)Execute the head cleaning. ( P.2-36)
(2)Remove the dust of the media.
(3)Clean dust on the platen.
(4)Clean the bottom of the carriage. ( P.4-10)
Media is raised during drawing and the
drawing stops.
(1)Set new media and start printing.
To Next Page
Loading...
