2-20
Setting rigid media
To set thick media such as a board (up to 10mm), attach the support tables on the front and the back of this
machine.
1
Set the front support table (the front of
this machine).
• The front support table has a stick (rigid media
retainer) shown on the right.
( 1 ) Lift up the table until it stops.
( 2 ) Raising the hooks on both sides of the support
table, insert them into the holes on both sides of
this machine.
• To prevent the rigid media being jammed into the Y bar, raise the head in advance.
( P.2-26)
• Work with 2 or more people.
• See also the separate manual “How to set Rigid Media” for setting.
• The position of the bars and rollers on the support tables can be changed depending on the
media width. Move their positions to set media flat.
Remove the screws on both sides of the bars or rollers, and attach them on the position that is
appropriate to the media used.
To Next Page
Loading...
