MIMAKI UJV-160 - Error Message

5-6
Error message
When an error message is displayed, follow the table below and solve the problem.
If the same error message is displayed again, contact a distributor in your district or our office.
Message Solution
• Turn the power of this machine off and turn it on after a while.
• If the same error message appears again, contact a distributor in your
district or our office to call for service.
• Securely connect the interface cable in position.
• Use an interface cable in conformance with the standard.
• Turn the power of this machine off and turn it on after a while.
• If the same error message appears again, contact a distributor in your
district or our office to call for service.
• Operate this machine correctly.
ERROR0 6
CHECK : SDRAM
ERROR0 7
HD CONNECT [ 12345678 ]
ERROR0 7
HD THERMIS[ 12345678 ]
ERROR0 7
HEAD T I M I NG
ERROR0 7
P-HEAD INIT
ERROR0 8
L-SCALE BLACK
ERROR0 9
HDC POSCNT
ERROR0 9
HDC F I FO OVER
ERROR0 9
HDC F I FO UNDER
ERROR0 9
HDC SPEED
ERROR0 9
FLUSHING BUSY
ERROR1 0
COMMAND
ERROR1 1
PARAMETER
ERROR1 2
Men t Command
ERROR2 5
USB I N I T ERR
ERROR2 5
USB T I ME OUT
ERROR3 0
OPERAT I ON
ERROR3 4
DATA REMA I N