1-10
Connecting the cables
Connecting the USB2.0 interface cable
Connect a computer to this machine with the USB2.0 interface cable.
● Notes on peripheral devices in USB high speed mode
When a peripheral device (USB memory or USB HDD) to be operated in USB high speed mode is
connected to the same personal computer that this machine is connected to, the USB device may not be
recognized.
When this machine is connected to the personal computer to an externally installed USB hard disk drive ,
the data output speed to this machine may drop. That can cause the head unit to stop temporarily at the
right or left end during printing.
Connecting the power cable
• Your RIP is required to support USB2.0 interface.
• If USB2.0 interface is not installed in your computer, ask a RIP vender near you or our branch
office.
• Use only the supplied power cable.
• Be sure to connect the power cable plug to the grounded outlet, or it may cause fire or electric
shock.
• Take care not to damage, break or work upon the power cable. Or if putting a heavy thing on,
heating, or pulling the power cable, the power cable can break to cause fire or electric shocks.
To Next Page
Loading...
