MIMAKI UJV-160 - Setting Media Compensation

3-9
3
Useful Function
Setting media compensation
When changing the type of media or the heater temperature, adjust the media feeding.
If wrongly adjusted, it may not print clearly such as stripes on the print.
1
Set a media. ( P.2-12)
2
When <LOCAL> is displayed, press the
key.
3
Press the key.
4
Select the type 1 to 4 with the or
key, and press the key.
• When the heater temperature is changed, check the [ CONSTANT ] lamps light and it has
reached the preset temperatures, and then adjust.
• When using roll media, the media returns to the print origin at the end of [MEDIA COMP.].
Then the roll media in the rear of this machine will slack.
Before printing, take up the slack in the roll media by hand. A slack may cause an inferior
image quality.
• When using the take-up device, set the media first, perform [MEDIA COMP.], and draw
images.
• Two bands are printed as the compensation pattern.
• Adjust so that the boundary between two bands becomes equal density.
Second band
First band
Media advance direction
Compensation pattern
<LOCAL . 1>
FUNCTION
FUNCT I ON
SET UP <ENT>
ENTER
SET UP
SELECT : TYPE1
ENTER