MIMAKI UJV-160 - CHAPTER 1 Before Use

In this chapter, the parts names and setting procedures before
use are explained.
Installing this machine.......................................... 1-2
Where to install .......................................................... 1-2
Working Environmental Temperature ........................ 1-3
Moving this machine .................................................. 1-3
Configuration and Function ................................. 1-4
Front/ Side ................................................................. 1-4
Rear/ Side of the main power switch ......................... 1-5
Support Table (Front/Back) ....................................... 1-6
Operation Panel ......................................................... 1-7
Carriage and UV LED Unit ........................................ 1-8
Wiper ......................................................................... 1-8
Flushing Tray ............................................................. 1-8
Heater ........................................................................ 1-9
Media Sensor ............................................................ 1-9
Connecting the cables ........................................ 1-10
Connecting the USB2.0 interface cable ................... 1-10
Connecting the power cable .................................... 1-10
Setting the ink cartridge ..................................... 1-11
Ink Type ................................................................... 1-11
About Media......................................................... 1-13
Usable media size ................................................... 1-13
Caution when handling the media ........................... 1-13
About antistatic sheet ......................................... 1-14
<LOCAL>and<REMOTE> .................................... 1-15
CHAPTER 1
Before Use