2-22
4
Set the rear support table (the back of
this machine).
• Unlike the front table, the rear support table does
not have a stick (rigid media retainer).
( 1 ) Lift up the table until it stops.
( 2 ) Set the support table so that the protrusions on
both sides of this machine come between the
concave parts of the support table.
( 3 ) For the base height, adjust in the same way as
the front support table (front of the machine).
( P.2-21)
5
After setting the support table, lock the
casters of the support table.
6
Turn the clamp lever to the front.
To Next Page
Loading...
