MIMAKI UJV-160 - Page 55

2-25
Setting media
2
Basic Operations
12
The media detection starts.
( 1 ) The media width is detected.
( 2 ) The media is fed and the rear end of the media is detected.
( 3 ) When the detection is completed, <LOCAL> is displayed.
• When a space between the media and the head is wide, a
screen shown on the right is displayed and the media cannot
be detected.
In this case, lower the head height. ( P.2-26)
• When a media comes onto the support table during drawing, set the rigid media retainer on the
media, and put it on the racks on both sides. The rigid media retainer prevents the media from
lifting.
DETECT I NG WI DTH
PLEASE WA I T
ERROR 5 0
WI DTH
Rigid media retainer