MIMAKI UJV-160 - Page 59

2-29
Setting media
2
Basic Operations
Media detecting method (detecting width manually)
1
Depending on the set media, press the
jog key and .
2
Specify the right edge position of the
media.
( 1 ) Press the keys to match the ORI-
GIN mark of the carriage with the right edge of
the media.
( 2 ) Press the key.
3
Check the position of the media left edge.
( 1 ) The carriage moves to the left edge of the
media depending on the media width set in
“Setting the media width ( P.3-18)”.
( 2 ) Check that the ORIGIN mark of the carriage is at the left edge of the media, and press
the key.
( 3 ) If it is not at the left edge of the media, press the keys to move the carriage.
(The displayed media width is also changed.)
4
The size of the detected media is
displayed.
• After a while, the mode returns to the local.
• When the carriage is at the waiting position, if you press the key, the right edge of the
media is automatically detected.
• When you selected “LEAF”, the rear edge of the media will be also detected.
• When you set the position on the platen, printing may be performed on the platen.
MED I A SE L ECT
ROL L < > L EA F
MED I A WI DTH DE TECT
RIGHT EDGE POS. :ent
ENTER
ENTER
MEDIA WIDTH = 1600mm
LEFT EDGE CHECK : en t
ENTER
** MEDIA **
X=**** y=****