Mindray Accutorr 7 Service Manual

3-2
NOTE
 The environmental specifications of unspecified accessories are the same as
those of the main unit.
3.2.3 Electrical Requirements
Check cables and power cords. Make sure that:
1. System cables, power cords, and power plugs are not damaged, and that the pins
are not loose. If damage is noted, discontinue use and replace.
2. Patient cables and connections are secure.
WARNING
 Use only properly grounded power outlets.
 Use the supplied power cord only!
Voltage
100 to 240V AC
Current
0.9
to 0.5A
Frequency
50/60 Hz
3.3 Equipment Installation
Follow the procedure below to install the equipment:
1. Ensure the unit and accessories are not damaged.
2. Install the battery (optional). For detailed operations, please refer to the operator’s
manual.
3. Connect AC power.
4. Connect the accessories.
Installation Support
The vital signs monitor can be mounted on a wall bracket or on a rolling stand. The wall
bracket or rolling stand can be ordered optionally. Each type of mounting bracket is
delivered with a complete set of mounting hardware and instructions. For detailed
installation information, please refer to Wall-mount Bracket Instructions for Use (PN:
0010-20-42933) and Rollstand Instructions for Use (PN: 0010-20-42934).
CAUTION
 Use only Mindray supplied or approved mounting solutions.
 The mounting bracket should be installed by qualified service personnel.

Mindray Accutorr 7 Specifications

General

Brand	Mindray
Model	Accutorr 7
Category	Medical Equipment
Language	English