Mindray Accutorr 7 - Disassembling the Temperature On-Position Detection Board PCBA

6-21
6.5.2 Disassembling the Temperature On-Position Detection Board
PCBA
1. Unscrew the four M3×6 screws as indicated and remove the temperature module
housing.
2. Unscrew the four M2 screws as indicated below and remove the Temperature
on-position detection board PCBA.
NOTE
 Remember to assemble the silicon button for the Temperature on-position
detection switch during reassembly.
T
emperature on-position detection board PCBA
To Purchase, Visit Avobus.com or call 1-800-674-3655