Mindray Accutorr 7 Service Manual

6-1
6 Disassembly and Repair
6.1 Tools Required
To disassemble and replace the parts and components, the following tools may be required:
 Philips screwdrivers
 Tweezers
 Sharp nose pliers
 Clamp

Slot-type screwdriver
6.2 Preparations for Disassembly
Before disassembling the equipment, finish the following preparations:
 Stop monitoring, turn off the equipment, and disconnect all the accessories and
peripheral devices.
 Disconnect the AC power source and remove the battery.
WARNING
 Before disassembling the equipment, be sure to eliminate the static charges
first. When disassembling the parts labeled with static-sensitive symbols,
make sure you are wearing electrostatic discharge protection such as
antistatic wristband or gloves to avoid damaging the equipment.
 Properly connect and route the cables and wires when reassembling the
equipment to avoid short circuit.
 Follow correct sequence to disassembly the equipment. Otherwise, the
equipment may be damaged permanently.
 Be sure to disconnect all the cables before disassembling any parts. Be sure
not to damage any cables or connectors.
 Place the screws and parts from the same module together to facilitate
reassembling.
 Use care during reassembly to ensure cables are properly routed and all
gaskets are intact and correctly positioned.

Mindray Accutorr 7 Specifications

General

Brand	Mindray
Model	Accutorr 7
Category	Medical Equipment
Language	English