8-2
8.1.2.2 Upgrading Masimo SpO
2
Contents of upgrade package:
A power management board assembly with Masimo SpO
2
; and,
A Masimo SpO
2
connector panel assembly.
1. Remove the power management board, connector panel assembly and the
stopple of multifunctional connector (if there is one) as described in section 6.3
Disassembling the Main Unit.
2. Install the power management board assembly with the SpO2 board and the
connector panel assembly in the service kit into the main unit as described in
section 6.3 Disassembling the Main Unit.
8.1.3 Upgrading Temperature
Contents of upgrade package:
A Temp
erature module with cables; and,
Two M3×6 screws.
Remove the decorative cover from the Temperature module connector. Install the
Temperature module onto the main unit as described in section 6.5 Disassembling the
Temperature Module (Optional).
8.1.4 Upgrading Wi-Fi (Only Available for Accutorr 7)
Contents of upgrade package:
Antenna sleeve
Wi-Fi antenna
Carrier board of wireless module (PCBA)
Radio module support IEEE 802.11a/b/g/n
Wi-Fi label
Three cross pan head screw M2X4
Follow this procedure to upgrade:
1. Install the Wi-Fi module onto the main unit as described in section 6.4
Disassembling the Front Housing Assembly.
2. Paste the Wi-Fi label.
To Next Page
Loading...
Need help?
General
