EMC
BP10 Operator’s Manual B - 3
• This device is intended for use by healthcare professionals only. This
equipment/ system may cause radio interference or may disrupt the
operation of nearby equipment. It may be necessary to take mitigation
measures, such as re-orienting or relocating the device or shielding the
location.
If the device is operated within the electromagnetic environment listed in Table
Guidance and Declaration — Electromagnetic immunity, the device will remain safe and
provide the following essential performance:
■ Operating mode
■ Accuracy
■ Function
■ Accessories identification
■ Data stored
■ Detect for connection
Guidance and Declaration — Electromagnetic Emissions
The device is intended for use in the electromagnetic environment specified below. The customer
or the user of the device should assure that it is used in such an environment.
Emissions test Compliance Electromagnetic Environment — Guidance
Radio frequency (RF)
emissions
CISPR 11
Group 1 The device uses RF energy only for its internal
function. Therefore, its RF emissions are very low and
are not likely to cause any interference in nearby
electronic equipment.
RF emissions
CISPR 11
Class B /
Harmonic Emissions
IEC61000-3-2
Not applicable /
Voltage Fluctuations/
Flicker Emissions IEC
61000-3-3
To Next Page
Loading...
