Mindray DC-30 Service Manual

3-26 System Installation
Only when the system is configured with DICOM basic function module, and installed
DICOM Worklist, MPPS, DICOM Structured Reporting and Query/ Retrieve modules, can
the corresponding preset settings be found in DICOM Service screen.
The DICOM Service Setting is used to set properties of DICOM services as Storage,
Print, Worklist, MPPS, Storage Commitment and Query/ Retrieve.The detail setting for
DICOM refer to User Manual chapter 10.
NOTE:
DICOM Worklist can be configured only after DICOM Basic is configured,
and if DICOM Worklist function is not configured, the “Worklist” page is not
accessible.

Mindray DC-30 Specifications

General

DICOM	Yes
Hard Drive	500 GB
Continuous Wave Doppler	Yes
Tissue Harmonic Imaging	Yes
Relative Humidity	30% to 85% (non-condensing)
Imaging Modes	Color Doppler, Power Doppler
Power Supply	100-240 V~ 50/60 Hz
Probe Connectors	2 active probe connectors
Probe Types	Convex, Linear, Phased Array
Operating Temperature	10°C to 40°C
Storage Temperature	-20°C to +55°C
Transducer Ports	2