Mindray TEX20 Operator's Manual

1 Important Information
Operator’s Manual 1 - 5
– Locations near heat generators.
– Locations with high humidity.
• Turn ON the system only after the power has been turned OFF for a while. If the system is
turned ON immediately after being turned OFF, the system may not be rebooted properly and
could malfunction.
• Select the Freeze to freeze an image or turn off the power of the system before connecting or
disconnecting a probe.
• Remove the ultrasound gel from the face of the transducer when the examination is completed.
Water in the gel may enter the acoustic lens and adversely affect the performance and safety of
the transducer.
• You should properly back up the system to a secure external storage media, including system
configuration, settings and patient data. Data stored to the system’s hard drive may be lost due
to system failure, improper operation or accident.
• If the system is used in a small room, the room temperature may rise. Please provide proper
ventilation and free air exchange.
• To dispose of the system or any part, contact Mindray Customer Service Department or sales
representative. Mindray is not responsible for any system content or accessories that have been
discarded improperly.
• Electrical and mechanical performance may be degraded due to long usage (such as current
leakage or distortion and abrasion); the image sensitivity and precision may become worse too.
To ensure optimal system operations, it is recommended that you maintain the system under a
Mindray service agreement.
• Refer replacing job to Mindray service engineers or engineers authorized by Mindray only.
• Do not turn OFF the power supply of the system during printing, file storage or invoking other
system operations. An interrupted process may not be completed, and can become lost or
corrupted.
• Ensure that the current exam date and time are the same as the system date and time.
• Use detachable power supply cord as mains power breaking device. DO NOT set equipment in
place where difficult for disconnection of detachable power supply cord.
Please read the following precautions carefully to ensure the safety of the patient and the operator
when using the probes.
WARNING
• The ultrasound probe is only for use with the specified ultrasound
diagnostic system.
• The ultrasound probe must be used only by qualified professionals.
• Confirm that the transducer and probe cable are normal before and after
each examination. A defective probe may cause electric shock to the
patient.
• Do not subject the probe to shock. A defective probe may cause electric
shock to the patient.
• Do not disassemble the probe to avoid the possibility of electric shock.
• Never immerse the probe connector into liquids such as water or
disinfectant because the connector is not waterproof. Immersion may
cause electric shock or malfunction.

Mindray TEX20 Specifications

General

Brand	Mindray
Model	TEX20
Category	Diagnostic Equipment
Language	English