2 System Overview
Operator’s Manual 2 - 21
2. Input a vocal command using the microphone, and after the command is recognized, the
system automatically performs the corresponding operation.
3. Select the icon in the Audio Control menu to pause the vocal command recognition.
Setup
Select the icon in the Audio Command menu to check the system recognizable commands
and enter the iVocal Setup menu.
• Add: Select [Add] to enter the Adding New Command menu, Select [Function Description] to
select the desired function, enter the user-defined command in the [Command] text box, and
then select OK.
User-defined command naming rules: only Chinese characters, English letters, and digits are
supported; the English letters are case-insensitive, consecutive blank spaces are not supported,
and a maximum of 128 letters are allowed when entering the English letters; Blank spaces are
not supported and a maximum of 30 characters are allowed when entering the Chinese
characters; the user-defined commands cannot be empty; User defined commands that are
already exited in the system but represent different functions are not supported to be added.
• Test: Select [Test] and input a vocal command to the microphone device. After the vocal
command is recognized, the Success Rate is displayed in fraction. Select [Test] again to close
the vocal command test.
If the vocal command is successfully recognized by the system, both the denominator and
numerator of the Success Rate are added by 1 for each time; if the vocal command fails to be
recognized by the system, the denominator of the Success Rate is added by 1 for each time
through selecting the icon, while the numerator remains the same. For example: 2/3
represents 2 times of success and 1 time of failure.
• Clear: Select [Clear] to clear all the Success Rate test records.
• Recover: Select [Recover] to enter the Confirm menu. You can select Yes to restore to the
default settings.
To Next Page
Loading...
Need help?
General
