3 - 12 Operator’s Manual
3 System Preparation
Perform the following procedure:
1. Plug the printer power cord to an appropriate outlet.
2. Power on the system and the printer.
3. Make sure the ultrasound machine and the printer are connected to a same LAN, and turned on
the W-LAN function of the printer.
4. Select in the top-right corner of the screen and select [Setup] > [System] > [Peripheral] >
[Print Service] to choose the report to be printed. Select the printer from the wireless printer
list, and set the printer.
5. Select [Save] to exit the preset and make the settings effective.
To Next Page
Loading...
Need help?
General
