Mirae Mx400 - Page 366

5-14 Mx-Series Manual
10002 -
10003
(AOP) Front ANC base
fails to move up or the
sensor does not work.
If the solenoid valve does not work,
check the solenoid valve according
to the check procedure. If not, check
the sensor according to the check
procedure.
10004 -
10005
(AOP) The front ANC
locking is not locked or
the sensor does not
work.
If the solenoid valve does not work,
check the solenoid valve according
to the check procedure. If not, check
the sensor according to the check
procedure.
Error Code
Message Description
Actions
References
10006 -
10007
(AOP) The Front ANC
pusher is not locked or
the sensor does not
work.
If the solenoid valve does not work,
check the solenoid valve according to
the check procedure. If not, check the
sensor according to the check
procedure.
10008 -
10013
(AOP) The Rear ANC
base fails to move up
or the sensor does not
work.
If the solenoid valve does not work,
check the solenoid valve according to
the check procedure. If not, check the
sensor according to the check
procedure.
10014
(AOP) The LED tower
of the CSP camera
fails to move up or the
sensor does not work.
Not applicable to Mx-120 Series
10016
(AOP) The Main
Stopper fails to move
up or the sensor does
not work.
If the solenoid valve does not work,
check the solenoid valve according to
the check procedure. If not, check the
sensor according to the check
procedure.
10017
(AOP) The Main
Stopper fails to move
down or the sensor
does not work.
If the solenoid valve does not work,
check the solenoid valve according to
the check procedure. If not, check the
sensor according to the check
procedure.
10018 -
10019
(AOP) The TF/shuttle
pallet is not fixed or the
sensors (1/2) do not
work.
If the solenoid valve does not work,
check the solenoid valve according to
the check procedure. If not, check the
sensor according to the check
procedure.
10020 -
10021
(AOP) The precision
camera LED tower fails
to move up or the
sensor does not work.
Not applicable to Mx Series
10022 -
10023
(AOP) Lock output /
lock sensor / unlock
sensor of the
TF/shuttle pallet lock is
abnormal.
If the solenoid valve does not work,
check the solenoid valve according to
the check procedure. If not, check the
sensor according to the check
procedure.