Mirae Mx400 - Page 367

Chapter 5 Solutions for Errors 5-
15
10024 -
10025
The shuttle holder fails
to move down.
(Component fixation
error)
If the solenoid valve does not work,
check the solenoid valve according to
the check procedure. If not, check the
sensor according to the check
procedure.
10026 -
10027
The shuttle holder fails
to move forward.
(Component fixation
error)
If the solenoid valve does not work,
check the solenoid valve according to
the check procedure. If not, check the
sensor according to the check
procedure.
10028 -
10029
Locking of the shuttle
tray does not work
normally.
If the solenoid valve does not work,
check the solenoid valve according to
the check procedure. If not, check the
sensor according to the check
procedure.
Error Code
Message Description
Actions
References
10030
Locking of the shuttle
rack fixation (up) does
not work normally.
If the solenoid valve does not work,
check the solenoid valve according to
the check procedure. If not, check the
sensor according to the check
procedure.
10031
Unlocking of the shuttle
rack fixation (up) does
not work normally.
If the solenoid valve does not work,
check the solenoid valve according to
the check procedure. If not, check the
sensor according to the check
procedure.
10032
Locking of the shuttle
rack fixation (center)
does not work
normally.
If the solenoid valve does not work,
check the solenoid valve according to
the check procedure. If not, check the
sensor according to the check
procedure.
10033
Unlocking of the shuttle
rack fixation (center)
does not work
normally.
If the solenoid valve does not work,
check the solenoid valve according to
the check procedure. If not, check the
sensor according to the check
procedure.
10034
Locking of the shuttle
rack fixation (down)
does not work
normally.
If the solenoid valve does not work,
check the solenoid valve according to
the check procedure. If not, check the
sensor according to the check
procedure.
10035
Unlocking of the shuttle
rack fixation (down)
does not work
normally.
If the solenoid valve does not work,
check the solenoid valve according to
the check procedure. If not, check the
sensor according to the check
procedure.
10036
Back pusher locking
error
Not applicable to Mx Series
10037
Back pusher unlocking
error
Not applicable to Mx Series