Using the TX3 Nano
TX3 Nano Configuration Manual 65
Copyright 2019
3. After you have selected the new password, select Save at the top of the
list.
4. Select Yes.
8.5.3 Enable the Default Static IP Address
By default, the TX3 Nano uses DHCP to get an IP address. To disable DHCP and
enable the default static IP address (192.168.1.128), follow these
instructions.
Enable the default static IP address (disable DHCP)
1. Connect the TX3 Nano to the network.
2. On the Panel Settings screen, select DHCP(Enabled).
3. Select Yes.
The TX3 Nano restarts.
DHCP is now disabled, and the IP address is 192.168.1.128, the subnet
mask is 255.255.255.0, and the gateway is 192.168.1.1.
Note: The DHCP option shows DHCP(Enabled) or
DHCP(Disabled) to indicate whether DHCP is currently
enabled or disabled. By default, DHCP is enabled.
8.5.4 Enable a Custom Static IP Address
To switch from DHCP to a static IP address, follow these instructions.
Enable a custom static IP address
1. Connect the TX3 Nano to the network.
2. On the Panel Settings screen, select Set IP.
3. Enter an IP address.
4. Select Save.
5. Select Set MASK.
6. Enter a subnet mask.
7. Select Save.
8. Select Set GATEWAY.
9. Enter a gateway IP address.
To Next Page
Loading...
