Mircom TX3 Series - Page 66

66 TX3 Nano Configuration Manual
Copyright 2019
Using the TX3 Nano
10. Select Save.
11. Select Enable Static IP.
12. Select, Yes, use new static IP.
The TX3 Nano restarts.
8.5.5 Enable DHCP
If you are using a static IP address and want to use DHCP instead, follow these
instructions to enable DHCP.
Enable DHCP
1. Connect the TX3 Nano to the network.
2. On the Panel Settings screen, select DHCP(Disabled).
3. Select YES.
The TX3 Nano restarts. After it restarts, DHCP is enabled.
Note: The DHCP option shows DHCP(Enabled) or
DHCP(Disabled) to indicate whether DHCP is currently
enabled or disabled. By default, DHCP is enabled.
8.5.6 Time Zone
By default, the TX3 Nano’s time zone is Eastern Standard Time. Follow these
instructions to change the time zone.
Note: After you change the time zone, you must restart the TX3 Nano.
Set the time zone
1. On the Panel Settings screen, select Set time zone and time.
2. Select Set time zone.
3. Select your continent.
4. Select your country.
5. Select your time zone.
6. Select YES.
7. Follow the instructions in section 8.5.8 on page 67 to restart the TX3
Nano.