68 TX3 Nano Configuration Manual
Copyright 2019
Using the TX3 Nano
8.5.9 Shutdown
Shut down the TX3 Nano
1. On the Panel Settings screen, select Shutdown.
2. Select Yes.
The TX3 Nano shuts down.
Note: To power on the TX3 Nano after it is shut down, unplug and plug
the PoE cable, or cycle the power supply that is connected to the
PoE router or switch.
If the TX3 Nano is not powered by PoE, then cycle the power
supply that the TX3 Nano is connected to.
To Next Page
Loading...
