Mitel 3000
Installation & Maintenance Manual
55
Power up and test
• Ensure the main AC power source plug is fitted with a 3A fuse.
Switch on
1. Power up the system by inserting the main AC power source plug.
2. Wait for the system power up routine to be complete. This can take up to 30 seconds.
Check that the vital activity LED is flashing. This is the top LED of the four LEDs in the CCU MDF area.
3. Make sure the Power LED is continuously lit. This is the third LED in the CCU MDF area.
Getting Started
1. Remove any anti-scratch protective film from the Feature Phone LCDs (Liquid Crystal Display).
2. Label all Feature Phone programmable keys and other telephones.
3. Reset the system to default.
4. Ensure that all Feature Phone’s provide dialing tone, ringing and handsfree (loud speaking) facilities. Check
that the display is not showing corrupt information.
5. Check that all other telephones are connected. Make sure all these phones ring and that you can dial from
them.
To Next Page
Loading...
Need help?
General
