Mitel 3000 - Firewall and Security Configuration; Security State Configuration

Mitel 3000
Installation & Maintenance Manual
61
System Programming from the Programming Telephone
You access all the System Programming options via the PROGRAM key on the Feature Phone connected to the
programming extension, extension 20 at power up.
1. From the Programming extension, press the PROGRAM key.
2. Press the Scroll Down key () until “System Programming” is displayed.
3. Select “System Programming”.
NOTE: Selecting “System Programming” from any extension other than the programming extension will result
in the prompt “Programming Refused” being displayed.
The following screen is displayed:
Enter System Password
- Exit
• Enter the System Programming Password, which is 1111 by default.
NOTE: You can also enter System Programming by dialing ##1111 at the programming extension and selecting
“Send Digits”.
The following screen appears offering options to configure the overall system, the extensions, or the lines.
Select Option
- System
- Extensions
- Lines
• Under “System”, you will find the programming options that affect the system as a whole.
• Under “Extensions”, you will find the programming options that affect the extensions.
• Under “Lines”, you will find the programming options that affect the incoming lines.