Mitel 3000 Installation And Maintenance Manual

Mitel 3000
Installation & Maintenance Manual
81
Selecting the Line Group that the Remote Notification calls are to use
The outgoing line group to be used for remote notification calls can be changed.
• From the Programming extension, press the PROGRAM key.
• Press the Scroll Down key () until “System Programming” is displayed.
• Select “System Programming”.
• Enter the System Programming Password and select “System”.
• Select “Remote Notification”.
• Select “Outgoing group”.
• Select the group.
•
Notification delay timer
The time interval between receiving a message and making the first remote notification attempt is programmable.
This is set at 15 minutes (900 seconds) in default and can be set between 1 and 30 minutes (60 - 1800 seconds).
• From the Programming extension, press the PROGRAM key.
• Press the Scroll Down key () until “System Programming” is displayed.
• Select “System Programming”.
• Enter the System Programming Password and select “System”.
• Select “Timers”.
• Select “Notification Delay”.
• Enter the value between 60 and 1800 seconds and press “Confirm”.
•
Notification interval timer
If a remote notification fails this is the time the system waits before retrying the call. This is set at 5 minutes (900
seconds) in default. The range is 1-15 minutes (60 - 900 seconds).
• From the Programming extension, press the PROGRAM key.
• Press the Scroll Down key () until “System Programming” is displayed.
• Select “System Programming”.
• Enter the System Programming Password and select “System”.
• Select “Timers”.
• Select “Notification Interval”.
• Enter the value between 60 and 900 seconds and press “Confirm”.
To Reset the System
There are two system reset options available – a warm and a cold reset.
1. From the Programming extension, press the PROGRAM key.
2. Press the Scroll Down key () until “System Programming” is displayed.
3. Select “System Programming”.
4. Enter the System Programming Password and select “System”.
5. Press the Scroll Down key () until “Reset Options” is displayed.
6. Select “Reset!” or “Reset To Default!”.
These are complete system resets, not individual extension resets.
Selecting “Reset!” (warm reset) will reset the system and cut off all established calls.
Selecting “Reset To Default!” (cold reset) will reset the system, cut off all established
calls and remove all programming from the system.
To Set the Call Logging Interface Speed
1. From the Programming extension, press the PROGRAM key.
2. Press the Scroll Down key () until “System Programming” is displayed.
3. Select “System Programming”.
4. Enter the System Programming Password and select “System”.
5. Press the Scroll Down key () until “Set v24 Baud Rate” is displayed.
6. Select “Set v24 Baud Rate”.

Mitel 3000 Specifications

General

Brand	Mitel
Model	3000
Category	Telephone System
Language	English